FSR CDA-2EQA User Manual

Page 2

PROPRIETARY INFORMATION

All information in this manual is proprietary to and the

property of FSR inc. This publication is protected by the Federal

of this document may be reproduced, transcribed, or transmitted,

in any form or by any means, without prior

explicit written permission from FSR inc.

Thanks for purchasing the FSR CDA - 2EQA, a 1 x 2 distribution
amplifier with equalization. In addition to scaling switchers, such as
the MAS-4100, FSR offers a full line of interfaces, line drivers,
distribution amplifiers, down converters, power sequencers and more.

Operators Safety Summary

The general safety information in this summary is for operating
personnel.

Do Not Remove Covers or Panels There are no user-serviceable
parts within the unit. Removal of the top cover will expose
dangerous voltages. To avoid personal injury, do not remove the
top cover. Do not operate the unit without the cover installed.
Power Source This product is intended to operate from a,
provided, wall transformer power source.

Use the Proper Power Cord Use only the power cord and
connector specified for your product. Use only a power cord that is
in good condition. Refer cord and connector changes to qualified
service personnel.

Do Not Operate in Explosive Atmospheres To avoid explosion,
do not operate this product in an explosive atmosphere.

AUDIO
Bandwidth:

20 Hz to 20 kHz (+/-0.05 dB)

THD + Noise:

0.01% @ 20 kHz at rated Max Output S/N

>98 dB

Noise Floor:

< 98 dB

Stereo separation:

-90 dB @ 1 kHz

AUDIO INPUT
Number/type:

2 stereo unbalanced

Connectors:

Two 3.5mm stereo mini connectors

Impedance:

10K Ohms unbalanced

Max level:

+6 dBm

AUDIO OUTPUT
Number/type:

1 Balanced Stereo (may be used in

unbalanced configuration)

Connector:

5 Position mini Phoenix

Impedance:

50 ohms

Gain:

+ 6 dB balanced or unbalanced

Maximum Level:

600 ohms: +12 dBm Balanced / +6 dBm

Unbalanced Hi – Z: +14 dBm Balanced /

+8 dBm Unbalanced

SYNC
Input level:

2.0 Vp-p to 5.0 Vp-p

Output level:

4.0 Vp-p into Hi-Z, 2.0 Vp-p into 75 ohm

Input Impedance:

511 ohms

Output impedance:

75 ohms

Polarity:

Positive or negative

Horizontal frequency: 15 kHz - 200 kHz
Vertical frequency:

30 Hz - 150 Hz

POWER

Wall Transformer (provided)
with locking connector

9Vac @ 500 ma