Fronius Primo (Online) - Manual (Page 11)

9
EN
Installation notes
Selecting wall
plugs and screws
Recommended
screws To install the inverter, the manufacturer recommends the use of steel or aluminium screws
with a diameter of 6 - 8 mm.
Mounting the wall
bracket
Installing the in-
verter on a mast
Example of a mast fixing kit
When mounting the inverter on a mast or a
vertical carrier, Fronius recommends the
use of a standard mast fixing kit.
This kit enables the inverter to be mounted
on round or rectangular masts with various
cross-sections.
IMPORTANT! Different fixings may be required to fit the wall bracket depending on the
type of underlying surface. Fixings are therefore not included in the scope of supply of the
inverter. The installer is responsible for selecting the right type of fixing.
NOTE! When mounting the wall bracket, ensure that the wall bracket is not
warped or deformed.
Fronius Primo
Installation Help ?