Fronius DC Box 60/12 - Manual (Page 34)

8
Fronius DC Box 60/12 Installation
Dowels and
Screws Depending on the surface, different dowels and screws may be required
for installing the Fronius DC Box 60/12. Therefore, these dowels and
screws are not part of the scope of delivery for the Fronius DC Box 60/12.
The installer is responsible for selecting the proper dowels and screws.
When selecting the location, please observe the following criteria:
-
Install on a solid surface.
- The ambient temperature may not fall below -25 °C nor exceed +55 °C.
- The Fronius DC Box 60/12 may be installed outside in sheltered
areas. Avoid direct contact with moisture.
- Should be protected from direct sunlight and direct exposure to the
elements.
- Should be installed under the solar modules where possible.
Selecting a
Location
NOTE! To prevent warping
of the Fronius DC Box 60/
12, the device should be
installed only on a flat
surface.