North bridge configuration – Foxconn P41A-G User Manual

Page 36

North Bridge Configuration

► Video Function Configure

Press to go to its submenu.

► Memory Remap Feature

This item is used to enable/disable memory remap feature. Its mainly for if you have a 64bit
OS and 4GB of RAM. Basically it allows you to remap the overlapped PCI memory above the
total physical memory.

► DRAM Frequency

This item is used to adjust the DRAM frequency. Select [Auto] for SPD enable mode. You also
can select a value manually such as [800 MHz].

► Memory Timing by SPD

This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a memory module. It
contains important information about the module's speed, size, addressing mode and various
other parameters, so that the motherboard memory controller (chipset) can better access the
memory device.

► Memory Hole

This item is used to determine whether the 15M-16M address field of memory is reserved for
the ISA expansion card.

► Initate Graphic Adapter

This item is used to choose the initate graphics controller which will be used as the primary
boot device.

► IGD Graphics Mode Select

This item is used to select the amount of system memory used by internal graphics device.

► PEG Port

This item is used to enable/disable PCI Express graphics port.

North Bridge Configuration

North Bridge Chipset Configuration

Help Item

► Video Function Configure

[Press Enter]

Memory Remap Feature

[Enabled]

PCI MMIO Allocation:4GB To 3328MB

DRAM Frequency

[Auto]

Memory Timing by SPD

[Enabled]

Memory Hole

[Disabled]

Initate Graphic Adapter

[PEG/PCI]

IGD Graphics Mode Select

[Enabled, 64MB]

IGD GTT Graphic smemory size [No VT mode, 2MB]

PEG Port

[Auto]

↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help

F9:Optimized Defaults

[Press Enter]