Formax V-STACK36 - Manual (Page 6)

4
1. Place a folded piece against the backstop so that
the fom sits between the backstop and the feed
belts. (Fig 1)
2. Holding the folded piece in positon, loosen the
black knobs on either side of the paper stop. (Fig
2)
3. Lower the paper stop down so that it is resting on
the top edge of the folded piece, then tighten the
blck knobs to hold the paper stop in position. For
quicker setup in the future note the position of the
backstop on the ruler guides. (Fig 3)
Fig1
Fig 2
Fig 3
Feed belts
SETTING THE VERTICAL PAPER STOP