Formax 402 Series, Rev. 2 - Manual (Page 6)

OPERATION
Place the jogger in its operating location and plug it into a self-governing electrical receptacle.
Place paper, envelopes or checks in the jogger bin(s) and turn the power/
vibration control knob clockwise to turn the jogger on and adjust vibration.
The vibration amplitude is changed by turning this knob. To turn the jogger off,
turn control knob all the way to counter clockwise until it clicks off. Note: FE
models eith serial # ending in “F” have an on/off switch, the control knob only
adjusts the vibration intensity
For best results, documents should be jogged for at least 15 to 30
seconds. For maximum efficiency, Formax recommends a maximum
load of 10 pounds for each of the 402 Series models.
2
PROBLEM: POSSIBLE CAUSE: SOLUTION:
Unit does not operate Defective control knob
Shorted wiring, loose connection,
no power to unit
Replace control knob
Repair
Unit has power but will
not vibrate
Unit in contact with rigid object or
adjacent surface
Defective controller
Defective flex plates
Isolate unit
Replace controller
Replace flex plates
Excessive noise when
operating
Armature and core
assemblies making contact
Air gap spacers may need to be
replaced or adjusted
TROUBLESHOOTING