Formax 402 Series - Manual (Page 4)

OPERATION
Place the jogger in its operating location and plug it into a self-governing electrical receptacle.
Place paper, envelopes or checks in the jogger bin(s) and turn the power/
speed control knob clockwise to turn the jogger on and adjust speed. The
vibration amplitude is changed by turning this knob. To turn the jogger off,
turn control knob all the way to the left until it clicks off.
For best results, documents should be jogged for at least 15 to 30
seconds. For maximum effi ciency, Formax recommends a maximum
load of 10 pounds for each of the 402 Series models.
2
PROBLEM: POSSIBLE CAUSE: SOLUTION:
Unit does not operate Defective control knob
Shorted wiring, loose connec-
tion, no power to unit
Replace control knob
Repair
Unit has power but will not
vibrate
Unit in contact with rigid object
or adjacent surface
Defective rectifi er
Defective leaf springs
Isolate unit
Replace rectifi er
Replace leaf springs
Excessive noise when
operating
Armature and magnet
assemblies making contact
Air gap spacers may need to be
replaced or adjusted
TROUBLESHOOTING