Formax FD 210M - Manual (Page 4)

2
OPERATION
SAFETY GUIDELINES
1. Loosen thumbscrews on each side guide.
2. Slide side guides to correct location based on
desired placement of crease.
3. Tighten thumbscrews.
4. Load paper by sliding through creasing channel
under mechanism cover.
5. Once the paper is aligned between the side
guides, grasp creasing handle and push down-
ward, then release. Handle will return to upper
position. NOTE: Do not push too hard. Excessive
force is not required to create the crease, and
may damage creasing mechanism.
To avoid injury, do not place fingers into the creasing channel.
To avoid damage to the unit, do not place any objects other than paper into the creasing channel.
TWO-PART CREASING (BOOK SPINE CREASING):
1. Measure sheet to be creased.
2. Move right side guide to correct location and tighten thumbscrew.
3. Align page to right side guide and press down handle to crease.
4. For second crease, move left side guide to correct location and tighten thumbscrew.
5. Align page to left side guide and press down handle to crease.