Cut mark, Turbo mode, Empty the waste bin – Formax FD 120 User Manual
Page 14: Reset counter, Clear jam
CUT MARK
The purpose of the cut mark is to compensate horizontal cut due to image shifting during printing.
R efer to page 11 for cut mark printing.
Hold
and press
to enable or disable cut mark. This will toggle (M) for mark and (N) for no
mark on the display.
TURBO MODE
1.
Hold
for
4
seconds.
2.
Press
to select “Normal Mode” or “Turbo Mode”.
3.
Press
to save settings.
EMPTY THE WASTE BIN
1. The cutter provides a waste bin full warning when the cutting count has reached 150.
The cutter will stop and “ Waste Bin Full” will be displayed.
2. Empty the waste bin and replace it back in to the machine.
3. Press
to clear the warning.
4. Press
to continue the cutting job.
RESET COUNTER
Hold
and
simultaneously to reset counter to 0.
CLEAR JAM
In case a jam occurs in the machine, follow these steps to clear jam.
1. Power off then pull out jammed paper toward feeding tray.
2. Press
to move the jammed piece toward the exit.
Page 14