Fluke Biomedical 56-6XX - Manual (Page 7)

Operation
Assembly Procedure
2
2-1
Section 2
Operation
2.1 Assembly Procedure
2.1.1 To facilitate installing the caster brackets, lay the opaque lower panel flat on a table with the
mounting holes extending over the table’s edge (see Figure 2-1).
Figure 2-1. Caster Brackets Assembly
2.1.2 If the vertical side channels are not welded to the lower panel, position them over the edges
as shown. The pre-drilled holes in the caster brackets and vertical side channels will line up
with the holes in the lower panel. Using the supplied hardware (screws, washers and nuts),
attach the brackets to the panel (see Figure 2-2).
For maximum safety convenience, the locking
casters should be on the same side of the panel
(see Figure 2-2).
NOTE