Fluke Biomedical 190N - Manual (Page 9)

Introduction
Battery Installation/Replacement
1
1-5
CAUTION
CAUTION
NOTE
CAUTION
To prevent battery leads from shorting on the
battery compartment’s conductive coating, ensure
that all four batteries are INSTALLED at all times.
Unit power must be left ON and batteries replaced
one at a time to prevent data loss when the log
modes activated and logged data is to be retrieved.
The equipment described in this manual is intended
to be used for the detection and measurement of
ionizing radiation. It should be used only by
persons who have been trained in the proper
interpretation of its readings and the appropriate
safety procedures to be followed in the presence of
radiation. Although the equipment described in this
manual is designed and manufactured in
compliance with all applicable safety standards,
certain hazards are inherent in the use of electronic
and radiometric equipment.
In the case of an Electro Static Discharge (ESD)
power down of the Model 190N, it is necessary to
reset the unit by cycling the power (turning the unit
off and then on). After reset, the unit will power up
in its normal operating mode