Fluke Biomedical 960CI-200 - Manual (Page 21)

Troubleshooting
7
7-1
Section 7
Troubleshooting
7.1 Troubleshooting
WARNING
Extreme care must be used when troubleshooting a system that
has power applied. All standard troubleshooting precautions
apply.
WARNING
Once a problem has been located, remove all power before
continuing with the repair.
CAUTION
Personnel performing the following procedure must be familiar
with the operation of the monitoring system and the location of
each piece of equipment used in the system.
If a problem develops, verify that the voltages at connection point inputs and outputs are present and that all wiring
is secure. Refer to Appendix B for drawings.
The 960CI-200 Communications Isolator Module must be returned to the factory for service if troubleshooting of the
module is necessary.
NOTE
If a problem cannot be resolved by using the drawings in
Appendix B while applying the troubleshooting instructions found
in this manual, please contact the Fluke Biomedical RMS Customer
Service Department at (440) 498-2564 for assistance.
(Blank Page)