Fluke Biomedical 859A-1-72 - Manual (Page 10)

Storage and Installation 3
3-2
Failure to install the equipment in accordance with
the information presented in the assembly drawings
could result in damage to the equipment.
NOTE
Refer to the applicable drawings in Appendix A of
this manual or in the “Applicable Drawings”
appendix of the pertinent system level manual.
The Model 859A-1-72 Controller is mounted close to the 859-1-50 Continuous Filter Air Sampler, and all
required wiring is connected through one connector. Electrical connections are made to a mating
connector, which runs to the P1 connector on the controller. For wiring information, refer to drawing
859A-1-3 and 859A-1-5 in Appendix A.
WARNING
Ensure that all power is removed, prior to installing
the controller.
CAUTION
Prior to power up, ensure the controller cable is
properly connected.
1. Apply power to the system.