Fluke Biomedical QA-ES II - Manual (Page 24)

QA-ES II
Users Manual
14
eju001.eps
Figure 3. Test Results Printout
Foot Switch Output
Relays (K11) activate a Foot Switch Output, located on
the right side of the Analyzer. Use this output to trigger
the foot switch input on the ESU under test for any of the
Analyzer test modes. Refer to “Foot Switch Control” later
in this manual.
ESU Tests with the Analyzer
This section describes the tests that the Analyzer can
conduct on an ESU, as well as the features available with
the Ansur QA-ES Plug-in software optional accessory.
There are five available test modes with the Analyzer, as
follows:
•
Continuous Operation
•
Single Operation
•
Power Distribution
•
RF Leakage
•
REM Test