Fluke Biomedical TNT 12000 Quick Start - Manual (Page 2)

TNT 12000 English Quick Reference Guide
Page 2
The TNT 12000WD system consists of a wireless detector and uses a
laptop computer as a display (computer not included).
Both the TNT 12000 and the TNT 12000WD use a wireless ZigBee™
communication protocol to communicate between detector and display or
laptop.
The TNT 12000 single array of solid-state sensors measure kV, Dose,
Dose Rate, Half Value Layer (HVL) and exposure time over the entire
diagnostic x-ray radiographic, fluoroscopic, mammographic and dental
ranges.
All measured values are displayed after each exposure so it is not
necessary to make a value preference selection prior to each exposure.
This functionality eliminates a typical step in the measurement routine.
Measured values can be recorded for archive and further analysis using
the TNT 12000 Excel Add-in Software (provided).
TNT 12000 Ansur Test Automation Software is also available (option) to
permit automated test routines that can assure the continuity and
accuracy of results.
Measurement
Making a measurement is simple. After removing the unit from the
carrying case, separate the detector and display from their clamshell
storage position.
Step one:
Turn on both the detector and display. The display will scan for the
companion detector and establish a wireless connection.
Fct100.bmp