Fluke Biomedical 660-6 - Manual (Page 9)

Introduction
Specifications
1
1-5
1.2.2 Phantoms
Material Acrylic Plastic
Thickness 15 cm
Diameter Model 660-7 Body Phantom: 32 cm (12.60 in)
Model 660-6 Head Phantom: 16 cm (6.30 in)
Probe Holes Arrangement: One on center, four around periphery (90
degrees apart, 1 cm in from edge)
Inside Diameter: 1.27 cm
Volume 3.2 cc
1.3 Receiving Inspection
Upon receipt of the unit:
1. Inspect the carton(s) and contents for damage. If damage is evident, file a claim with the carrier and
notify Fluke Biomedical, Radiation Management Service at 440.248.9300.
2. Remove the contents from the packing material.
3. Verify that all items listed on the packing list have been received and are in good condition.
If any of the listed items are missing or damaged,
notify Fluke Biomedical.
1.4 Storage
If the unit is to be stored prior to use, pack it in the original container(s), if possible, and store in an
environment free of corrosive materials, fluctuations in temperature and humidity, and vibration and
shock.
The equipment described in this manual is intended
to be used for the detection and measurement of
ionizing radiation. It should be used only by
persons who have been trained in the proper
interpretation of its readings and the appropriate
safety procedures to be followed in the presence of
radiation.
Although the equipment described in this manual is
designed and manufactured in compliance with all
applicable safety standards, certain hazards are
inherent in the use of electronic and radiometric
equipment.
NOTE
CAUTION