Worcester actuation systems – Flowserve DFP17 User Manual

Page 25

WCAIM2037

DataFlo Digital Electronic Positioner DFP17 Installation, Operation and Maintenance Instructions

Figure 9

The following screen appears when the ICP program is first started:

The following screen appears after the Positioner Default Data is Loaded: (Some values may vary)

Flow Control

Worcester Actuation Systems

Security Code:
Unit Address:
Output Current Rng (mA):
Setpoint Direction
Split Range Start (%):
Split Range End (%):
Ramp Open Time (sec):
Ramp Close Time (sec):
Setpoint Function:
Dead Band:
Loss of Sig Position:
Loss fo Sig Time:
Power-on Position:
Power-on Time:
Lower Limit (%):
Upper Limit (%):
Tight Shutoff OK?:
Full Open OK?:
Brake ON Time (sec):
Run Cycles:
Deviation Alarm (sec):
Over-travel Alarm (%):
Under-travel Alarm (%):

Input:
PC Cmd:
Output:
Shaft Pos:
DB Run:

Over

Under

Dev

Therm

Open Time:
Close Time:
Cycle Time:

Load File

Save File

Toggle Control

Free Curve Edit

F10

Text Area Edit

F12

Change Position

↔

Dec/Inc Position

Alt-x

Exit Program

Comm Link:

Status

Alarms

Calibration Data

Ver. x.xx

Security Code:

XXXX

Unit Address:

Output Current Rng (mA):

4-20

Setpoint Direction:

RISE

Split Range Start (%):

Split Range End (%):

100

Ramp Open Time (sec):

Ramp Close Time (sec):

Setpoint Function:

LINEAR

Dead Band:

0.5

Loss of Sig Position:

Loss fo Sig Time:

Power-on Position:

Power-on Time:

Lower Limit (%):

Upper Limit (%):

100

Tight Shutoff OK?:

Full Open OK?:

Brake ON Time (sec):

0.25

Run Cycles:

Deviation Alarm (sec):

Over-travel Alarm (%):

100

Under-travel Alarm (%):

Input:

45.0%

PC Cmd:

50.0%

Output:

12.0 mA

Shaft Pos:

50.1%

DB Run:

0.5%