Flowserve ARV2 - Manual

ARV2
Ball Check Valve
Recommended Installation Practices
Vertical installation
The proper valve installation is with the flow direction from the bottom up.
The flow arrow on the body indicates the direction of flow. A minimum of 1
psi is necessary to move the ball off of the seat. With no positive stream
pressure, the ball will seat against back flow by gravity. (If the desired
direction of flow is from the top down, a standard ball will not allow the
valve to check against back flow with fluid pressure being exerted from the
bottom. Contact your local Flowserve Representative for assistance).
Horizontal installation
The Atomac ARV2 ball check valve will function properly in a horizontal
application when installed correctly. First, ensure the pipe line is
relatively level. The ball should not be restricted from checking by the
pull of gravity.
The ball will check properly when exposed to back flow conditions.
However, in the horizontal position, the media must be liquid to provide
adequate force to seat. (When installed horizontally the valve may not
provide adequate back flow protection in a gas service).
Installation precautions
Do not install a ball check valve directly to the inlet or discharge side of a
pump. Due to the flow characteristics introduced by the vortices produced
by a running pump, allow approximately 10 pipe diameters installation
distance from the pump.
When installing this fully lined product into fully lined pipe, a pipe flange
gasket is not necessary. The valve body to lined flange fitting is self
gasketing. However, if installing into a metallic piping system, a separate
flange gasket is recommended to prevent putting flange serrations into the
valve gasket surface.
The flange connection torques that should be used are those published by
the lined pipe supplier. Install the fasteners using the crisscross method
to ensure proper loading of the gasket connection. Improper torque
loading or over torque loading may damage both the valve gasket
connection as well as the flange gasket connection.