Flowserve Circpac MD - Manual (Page 6)

6
2.13 Center the housing assembly on the shaft
as required. If centering devices are used,
release any housing supports so that the
centering devices are properly engaged on
the shaft.
2.14 Evenly tighten the housing to the
equipment until the face gasket is fully
compressed and the housing is squarely
seated. Torque housing bolts to 34 N-m
(25 ft-lbs) minimum.
2.15 Remove centering devices, if applicable.
2.16 Connect piping if required.
Figure 12
Figure 13