Flowserve PSS II - Manual (Page 2)

2
These instructions are to be used in conjunction with the PSS II Repair
Kit. The Repair Kit contains replacement seal faces, secondary seals,
Loctite 430 adhesive, and Dow Corning 111 Silicone grease. Other
small parts are shown in Figure 1. The repair should be done in a clean,
well lit area. The tools you will need to do the repair include:
• Suitable solvent and rinse
• Alcohol
• Paper towels and/or swabs
• Single edged razor blade or Exacto style knife
• Common screw driver
• Hex key wrenches
• Paper clip
• Anti-seize thread compound
These instructions require the gluing of elastomers into position with
Loctite 430. As with any cyanoacrylate, extreme care must be used when
handling Loctite 430. See the enclosed Material Safety Data Sheet for
details.
For special problems encountered during the repair procedure,
contact your nearest Flowserve Sales and Service Representative or
Authorized Distributer.
Figure 1
1 Registered Trademark of Loctite Corporation
2 Registered Trademark of Dow Corning Corporation
® 1 ® 2
TM