Flowserve ISC2 Dual Pusher Repair - Manual (Page 2)

ISC2-PP
1.875
316 SS
Part references in this document are denoted in square parenthesis, e.g. [15]
Refer to the Bill of Material for proper placement of material-specific
components.
Notes for all seal sizes:
• Inboard and outboard stationary faces [14] and [14.1] are
interchangeable.
• Inboard and outboard rotating faces [15] and [15.1] are
interchangeable.
• Inboard and outboard stationary face supports [100] and [100.1] are
interchangeable.
• O-rings [13], [13.1], [13.2], [13.3], [76] and [76.1] are interchangeable.
2
1 Nomenclature
19 183 14 100 11 16 71 111 183 15.1 14.1 11.1 a16 57 58 103 40
1 76 15 13 13.1 5 18 99 18.1 5.1 76.1 13.2 5 100.1 13.3 57.1
Part Description
Ref.
1 Sleeve Assembly
5 Square-headed Pin
5.1 Drive Pin
11 Inner Gland
11.1 Outer Gland
13 Inboard Seat Gasket O-ring
13.1 Inboard Seat Gasket O-ring
13.2 Outboard Seat Gasket O-ring
13.3 Outboard Seat Gasket O-ring
14 Inboard Stationary Face
14.1 Outboard Stationary Face
15 Inboard Rotating Face
15.1 Outboard Rotating Face
16 Springs
18 Gland Gasket
18.1 Inner Gland O-ring
Figure 1
Sizes
≤ 2.750 inch
(70 mm)
Sizes
> 2.750 inch
(70 mm)
Part
marking
sample
19 Sleeve Gasket O-ring
40 Cap Screw
57 Cup-point Set Screw
57.1 Quarter-dog Set Screw
58 Drive Collar
71 Rotating Face Support O-ring
76 Inboard Rotating Face O-ring
76.1 Outboard Rotating Face O-ring
99 Rotating Face Support
100 Inboard Stationary Face Support
100.1 Outboard Stationary Face Support
103 Setting Device
111 Snap Ring
183 Vibration Dampener