Fli Audio FU5C - Manual (Page 4)

4
Tweeter Installation
The tweeter can either be fi tted fl ush mount or surface mount. Try and take into
account the following when locating a suitable position. For optimum staging try and
locate a position that is higher than the woofer but within twelve inches (maximum) of it.
It is vital that the tweeter is adjusted so that it is focused towards the listener.
surface mount tweeter installation
• After fi nding a suitable position for the tweeters place the base of the tweeter casing in the
correct position.
• Using this base mark the two mounting holes and the hole for the wire to pass through.
• Cut out these holes using a 2mm drill for the fi xing screws and at least an 8mm hole for the cable,
ensuring that the hole cut for the cable is big enough and will not cause the cable to become chaffed
in any way.
• Pass the
tweeter cable
through the
bottom of the
case and through
the previously
drilled hole.
• Secure the bass of
the tweeter housing
with the screws
provided.
• Finally, angle the
tweeter so that it is
focused towards the
listener.
Wiring diagram
+ -
+ -
+
-