Fire Magic 3587 Sink - Manual (Page 2)

REV 4 - 1301300830 L-C2-270 2
SINK INSTALLATION (cont.)
INSTALL DRAIN ASSEMBLY
1. Pull out the plug from the drain assembly, and
remove the exposed retaining bolt using a
Flathead screwdriver or a
9 / 16 " nut driver (see
Fig. 2-1).
2. Separate the upper drain fi tting from the remainder
of the drain assembly, being sure to keep one
rubber gasket on each part (see Fig. 2-2).
3. Turn the sink on its side, and insert the upper
drain fi tting into the hole on the bottom of the sink.
Ensure the ribbed gasket is between the metal
of the sink and the fi tting. See Fig. 2-3.
4. Insert the retaining bolt into the upper drain fi tting.
With the grooved gasket resting in the lower
drain assembly, orient the assembly against the
bottom of the sink, align with the retaining bolt,
and hand tighten. See Fig. 2-4.
5. Complete tightening by using the screwdriver /
nut driver to apply a fi nal quarter-turn.
Fig. 2-1 Remove drain plug and retaining bolt
Fig. 2-2 Remove upper drain fi tting
Fig. 2-3 Insert upper drain fi tting in sink
Fig. 2-4 Insert retaining bolt and attach lower drain
(A) Remove
drain plug
(B) Remove retaining bolt
Ribbed gasket Grooved gasket
(bottom of upper
drain fi tting)
Ribbed gasket
Upper drain
fi tting
(A) Insert retaining bolt
(from inside of sink)
(B) Attach lower drain assembly