FiberPlex MD-3 - Manual (Page 2)

2
RS-422 RS-232 MIDI
MD-3
RS-422 MIDI RS-232
OUT IN
MD-3 Front Panel
RS-232 connector – This connector is used to input RS-232
control data at the “send” origination end, and / output RS-232 control
on the “receive” or destination end.
MIDI Connector – This connector is used to input MIDI control
data at the “send” origination end, and output MIDI control data at the
“receive” or destination end.
RS-422 connector – This connector is used to input RS-422
control data at the “Send” origination end and output RS-422 control
data at the “receive” or destination end.
MD-3 Rear Panel
RJ45 connector #1 – Connects the RS-422 output data to the
MD-3 of the LightViper “control circuit” connector on the “send” side of
the chain, and connects the output of the “control circuits” connector
to the MD-3 on the “receive” side of the chain.
RJ-45 connector #2 – Connects the MIDI output data to the MD-
3 of the LightViper “control circuit” connector on the “send” side of the
chain, and connects the output of the “control Circuits” connector to
the MD-3 on the “receive” side of the chain.
MIDI Send / Receive switch - This switch must be set to the
appropriate “send” or “receive” setting as MIDI requires this setting to
correctly send / receive MIDI data.
RJ-45 connector #3 – Connects the RS-232 output data to the
MD-3 of the LightViper “control circuit” connector on the “send” side of
the chain, and connects the output of the “control circuits” connector
to the MD-3 on the “receive” side of the chain.
4
1
2
3
5
7
6
7 6 5 4 1 2 3