FiberPlex VRK-1832 - Manual (Page 3)

Class I Equipment (Mains Operation)
Should the equipment be delivered without a matching mains cable, the latter must be prepared by a trained person using the attached female
plug (Neutrik™ powerCON TRUE1) with respect to the applicable regulations in your country.
Before connecting the equipment to the AC power outlet, check that the local line voltage matches the equipment rating (voltage, frequency)
within the admissible tolerance. The equipment fuses must be rated in accordance with the specifications on the equipment.
Equipment supplied with a 3‐pole appliance inlet (protection conforming to class I equipment) must be connected to a 3‐pole AC power outlet so
that the equipment cabinet is connected to the protective earth.
WARNING :
If the ground is defeated, certain fault conditions in the unit or in the system to which it is connected can
result in full line voltage between chassis and earth ground. Severe injury or death can then result if the
chassis and earth ground are touched simultaneously.
Warranty, Service and Terms and Conditions of Sale
For information about Warranty or Service information, please see our published ‘Terms and Conditions of Sale’. This document is available on
fiberplex.com or can be obtained by requesting it from [email protected] or calling 301.604.0100.
Disposal
Disposal of Packing Materials
The packing materials have been selected with environmental and disposal issues in mind. All packing material can be recycled. Recycling packing
saves raw materials and reduces the volume of waste. If you need to dispose of the transport packing materials, recycling is encouraged.
Disposal of Used Equipment
Used equipment contains valuable raw materials as well as substances that must be disposed of professionally. Please dispose of used equipment
via an authorized specialist dealer or via the public waste disposal system, ensuring any material that can be recycled has been. Please take care
that your used equipment cannot be abused. After having disconnected your used equipment from the mains supply, make sure that the mains
connector and the mains cable are made useless.
Declarations of Conformity
Class A Equipment ‐ FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide a reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at their own expense.
Disclaimer
The information in this document has been carefully checked and is believed to be accurate at the time of publication. However, no liability is
assumed by FiberPlex for inaccuracies, errors, or omissions, nor for loss or damage resulting either directly or indirectly from use of the information
contained herein.