FiberPlex VIM-1032 - Manual (Page 3)

1
Warning for Your Protection
1. Read these instructions
2. Keep these instructions
3. Heed all warnings
4. Follow all instructions
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding‐type plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit
from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip‐over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged
in any way, such as power‐supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
The apparatus shall not be exposed to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the apparatus.
“WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.”
General Installation Instructions
Please consider besides these general instructions also any product‐specific instructions in the “Installation” chapter of this manual.
Unpacking
Check the equipment for any transport damage. If the unit is mechanically damaged, if liquids have been spilled or if objects have fallen into
the unit, it must not be connected to the AC power outlet, or it must be immediately disconnected by unplugging the power cable. Repair
must only be performed by trained personnel in accordance with the applicable regulations.
Installation Site
Install the unit in a place where the following conditions are met:
 The temperature and the relative humidity of the environment must be within the specified limits during
operation of the unit. Relevant values are the ones at the air inlets of the unit.
 Condensation must be avoided. If the unit is installed in a location with large variation of ambient temperature
(e.g. in an OB‐van), appropriate precautions must be taken before and after operation.
 Unobstructed air flow is essential for proper operation. Air vents of the unit are a functional part of the design
and must not be blocked in any way during operation (e.g. by objects placed upon them, placement of the unit on
a soft surface, or installation of the unit within a rack or piece of furniture).
 The unit must not be heated up by external sources of heat radiation (sunlight, spot lights).