Fenix Therm 105 - Manual (Page 25)

23
EN
3. Connect power, voltage 230 VAC,
load and floor sensor cable.
Any extension to the floor sensor cable
must be by means of high-voltage
current. Protective conductor for
incoming feed and for heating cable
is connected with a connection clip in
the box. See wiring diagram below.
4. Insert the thermostat into the ap-
pliance box and screw tight with the
existing screws.
5. Mount frame, front and knob.
6. If the thermostat is mounted in a
multi-compartment frame, the internal
corners of this frame must be removed.
LOAD LOAD
N L
SENSOR SENSOR DO NO
T USE
230 V