Fenix V25 User Manual
Page 6
6
V25 Plug Receiver
1.
Presentation
-
The V25 receiver is a plug mounting receiver, specially designed to control
electrical radiator regulation in combination with a wireless thermostat V22 type.
-
This couple (Thermostat Receiver) can also be managed by a Central V24 to
have full control of your heating installation from one point.
-
The V25 receiver can be used as slave unit of a V23 receiver.
-
Possibility to use the V25 receiver as On/Off Timer in combination with a V24
Central unit.
2.
Technical characteristics
Environment. (Temperatures)
Operating :
shipping et storage :
0°C - 40°C
-10°C to +50°C
Power supply
230Vac 50Hz by European plug socket
Electrical protection
Class II - IP20
Output
Maximum Load
Relay 16Amps 250VAC
Up to 16A - 250Vac 50Hz (by European plug socket)
Radio Frequency &
RF Receiving distance
868MHz < 10mW (Bidirectional communication)
Range of approximately 100m in open space.
Range of approximately 30m in residential environment.
Norms and homologation:
Your thermostat has been designed in
conformity with the following standards or
other normative documents:
EN 60730-1 : 2003
EN 61000-6-1 : 2002
EN 61000-6-3 : 2004
EN 61000-4-2 : 2001
EN300220-1/2
EN301489-1/3
R&TTE 1999/5/EC
Low voltage 2006/95/CE
EMC 2004/108/CE
Status LED (RED/Green)
Green:
Standby mode
Red:
Heating demand (Output on)
OFF:
Off mode
ON/OFF button
Short press: On/Off
RF Configuration button
Short press: Instantaneous RF transmission
3sec press: Thermostat or Central RF init.
5sec press: Slave receiver init.
15sec press: Reset of the receiver.
RF LED (Green)
Fixed:
RF configuration.
Flash:
RF reception
OFF:
Standby
Blink:
RF Alarm
Red:
Blink:
Timer 2H running
Timer 2H button
Short press: On/Off
(This function will not be fit back
to the V22 thermostat)
GB