EXCALIBUR PR11BK Motorized Bumper Boat User Manual

Page 3

6. Screw the large plastic hexagon nut onto the top of the

battery compartment to secure the control arm

in place.

7. Insert 6 D-cell batteries into the battery compartment,

making sure to match the polarity (+ and -) with the

diagram inside the battery compartment.

8. Carefully align the battery compartment cover

by matching the “3” that is printed on both the cover

and compartment.

9. Fasten the nuts with the wrench. It is generally best

to start at the two nuts directly across from the handle,

then the two nuts on both sides of the handle, then the

last remaining two.

10. Insert the electrical connection shaft into the motor

subassembly that encloses the propeller.

11. Hold the Bumper Boat vertically. This will make it

easier for the ﬁ nal steps of the assembly.

12. Insert the control arm sleeve into the hole located at

the front-center of the Bumper Boat.

13. Insert the control arm through the top of the control

arm sleeve. Insert the electrical connection shaft

through the bottom of the control arm sleeve.

14. From the bottom of the Bumper Boat, you can see

the “1” printed on both sides of the control arm and

propeller.

15. Push up the electrical connection shaft and make sure

that it is tightly secured into the propeller.

16. You have ﬁ nished assembling the Bumper Boat.