DCS MO24SS - Manual (Page 5)

4
Unpacking and Examining Your Oven
Remove: all packing materials from inside the oven
cavity; however, DO NOT REMOVE THE WAVEGUIDE
COVER, which is located on the right cavity wall. Read
enclosures and SAVE
the Operation Manual.
Check the oven for any
damage, such as mis-
aligned or bent door,
damaged door seals and
sealing surfaces, broken
or loose door hinges and
latches and dents inside
the cavity or on the door.
If there is any damage,
do not operate the oven
and contact your dealer or DCS AUTHORIZED
SERVICER.
Choosing a Location for Your Oven on
the counter
You will use the oven frequently so plan its location
for ease of use. It’s wise, if possible, to have counter
space on at least one side of the oven. Allow at least 2
inches on the sides, top and at the rear of the oven for
air circulation.
Choosing a Location for Your Oven if built-in
Your oven can be built into a cabinet or wall by itself
or above any DCS wall oven listed below using DCS’s
Built-in Kits, either the MOTK-27SS or the MOTK-30SS.
The MOTK-27SS is for a 27" wall oven, while the
MOTK-30SS accommodates installation above 30"
wall ovens.
See Built-in Kit Installation Instructions for proper loca-
tion when building in above the specified wall ovens.
Carefully follow both the wall oven installation instruc-
tions and Built-in Kit instructions.
The opening in the wall or cabinet must be within the
following dimensions:
A HEIGHT : 16 3 / 4 " to 17"
B WIDTH : 24 3 / 8 " to 24 11 / 16 "
C DEPTH : minimum 20"
OVER OVEN INSTALLATION
MICROWAVE
CUTOUT
2"
(51MM)
WARMING
OVEN CUTOUT
RECOMMENDED
HEIGHT
36"
(914MM)
MICROWAVE
CUTOUT
1"
(25MM)
TOP OF
MICROWAVE
SHELF
40 1/4"
(1022MM)
WALL
OVEN CUTOUT
OVER WARMING OVEN INSTALLATION
The applicable wall ovens and warming ovens are
as follows:
OVENS - WO 127, WO 130
WARMING OVENS - WD 27, WD 30
Do not built-in above any other gas or electric
wall oven.
TRIM KIT FRAME
ASSEMBLE
OVEN FRONT
Unpacking and Installation Instructions
2.DCS MO24SS / B268 10/31/2001, 4:25 PM 4