ETA Bruno - Manual (Page 28)

– Only use the clipper on dry hair.
– Do not use on freshly washed hair.
– Before you begin, comb the hair in the direction of growth.
– To achieve optimal clipping results, always move the clipper slowly through the hair
against the direction of hair growth.
– When the appliance is in operation, the A2 light is green, when the battery power reaches
minimum, the light begins to flash red. It is a signal to charge the battery.
Clipping with hair comb attachment
You may use 2 kinds of comb attachments C for trimming, depending on the attachment
(B1, B2) used.
1) Choose one of the two cutting attachments ( B1, B2), on which you may then put on
the comb attachments C arbitrarily, depending on the desired haircut length. Put this
attachment on properly.
2) Put on the desired comb attachment C depending on the chosen size of the attachment.
Then you can turn on the appliance. One of the C1 attachments has variable size of the
cut (12-23 mm).
3) If you are trimming for the first time, begin by trimming with an attachment of max. length
to prevent too short of a cut. When you have familiarized yourself with the settings, use
attachments C with lower length.
4) You may also use the blade cut length switch A4 for finer cut setting.
5) Make sure that the flat part of the comb is always in full contact with the scalp to obtain
an even result.
6) Move the clipper slowly over the crown from different directions to achieve an even result.
7) Always move the clipper against the direction of hair growth.
8) Make overlapping passes over the head to ensure that all hair that should be cut has
been cut.
9) Turn the Clipper off and remove the hair comb often to blow and/or shake out hair that
has accumulated.
Contouring without the hair clipping comb attachment
Choose the appropriate attachment B1 or B2 depending on your desired length of cut.
For more precise styling and trimming you may use the narrow mini-attachment B5.
1) Remove the hair comb (if it is attached). Be careful when you are clipping without comb
attachment as when the clipper is turned on it will trim every hair it touches.
2) Tilt the clipper in such a way that only one edge of the trimming attachment touches the
hair ends when you shape the contours around the ears.
3) To contour the nape of the neck or hairline, turn the clipper and hold it with the trimming
attachment pointing downwards.
4) To contour the sideburns, turn the clipper and hold it with the trimming attachment
pointing downwards.
Note
You may also use the blade cut length switch A4 for finer cut setting.
i
Trimming Nose Hair
1) Make sure nasal passages are clean.
2) Place nose, ear and eyebrow attachment B3 on Clipper.
3) Switch the Clipper on and insert the tip of the attachment into one nostril.
GB
28 / 53