ETA Josh User Manual
Page 17

socket in the stand
C1 or into socket A7 in the appliance, then plug the fork of the adaptor
into the mains. An indicator light
A2 will light up. To ensure full capacity of the rechargable
batteries, charge the appliance for approx. 16 hrs before first use and then discharge it
by using it regularly. Every other recharge takes approx. 8 hours. Fully charged batteries
provide operation time for approx. 50 minutes.
When using the adaptor, a continuous operation should not exceed 45 minutes. Then let
the appliance cool off for 10 minutes.
The appliance heats up during charging or operation, which is normal.
After charging, unplug the adaptor from the mains first and only then unplug the connector
from the appliance.
Recommendation: Discharge the battery every 6 months by regular use of the trimmer
(without the adapter being connected to the power supply). Then
charge the trimmer fully again.
Use
We recommend oiling the blades with the oil attached (pic. 5). You may use the appliance
without attachment – for trimming contours or with a selected attachment
B according to
a desired hairstyle length. Slide the attachment on the appliance head onto the guiding
grooves in a way that it locks in the protrusions
A4. Proceed reversely when taking the
attachments off. Wash, dry and brush your hair with a brush before trimming. Turn the
appliance on with the switch
A1. Hold the appliance with ease so that you can control
it perfectly. Trim off only little bits of hair first to get used to the length of hair which the
attachment offers. For an even haircut never go through the hair fast. The clippers work
best at their own pace. Turn the clippers off with the switch
A1 after finishing.
Cutting hair with the use of the attachments
1. We recommend first trying the attachment
B2 and only then, if you wish for a shorter cut,
use the attachment
B1. Always turn the clippers with a switch A1 before changing the
attachments. Set the length of the cut by turning the control
A5 to position 1 to 5 (in each
position, an audible click will sound). The selected length of cut is marked by an arrow
on the left side of the clippers.
2. Comb the hair in the direction of its natural growth.
3. Start cutting by shortening the hair on the sides from below to the top. Guide the trimmer
slowly against the hair with the adapter leading upwards, but flatwise along the head.
Lift up the appliance slowly and offward head. Cut only small volume of hair in each
stroke.
4. Repeat step 3 on the sides and on the back around the whole head.
5. Start trimming hair on the top of the head from front to the back with the adapter teeth
held along the head. In the first couple of trimmings it is recommended to leave hair
longer.
Cutting contours
1. No adapter is used for aligning contours.
2. Comb the hair in the required style.
3. Set the trimmer between hairline and ear. Check whether the corner of the trimmer
blades is set against hairline. Follow the hairline and go round the ear slowly with the
trimmer upwards and to the back. Do not push on the trimmer.
4. At the back on the neck and by the sideburns, hold the appliance against the skin and
go down at the required length.
17
GB