ETA Liliana - Manual (Page 17)

II. DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES
A – hair dryer
A1 – temperature and air flow intensity regulator
position – maximum temperature and air flow intensity
position – medium temperature and air flow intensity
position – minimum temperature and air flow intensity
position – off
A2 – handle
A3 – hanging loop
A4 – power cord
A5 – button (by pressing and holding the button, heating of the outgoing air is
interrupted and thus the air temperature is reduced, which enables
quick cooling and fixation of hair in the final hair styling)
A6 – joint (for tilting the handle when the dryer is transported or stored)
B – adapters
B1 – concentrator (used for concentrating air to the specific place)
B2 – diffuser (used for hair styling; close contact with scalp has to be avoided;
otherwise hair can get overdried)
C – case
III. INSTRuCTIoNs FoR use
Remove all packing material and take out the dryer with its accessories. Remove all
possible adhesion foils, stick-on labels or paper from the appliance. Lift off the handle A2
to the operating position so that its arrest is ensured. Plug the power cord A4 to a socket.
Put the adapter B on the dryer.
Hair drying
For quick hair drying, turn the switch A1 to the position of the maximum temperature and
the maximum air flow. For drying short hair or for finishing hair drying, set the switch to
the lower positions. Direct the outgoing air to hair while keeping the dryer handle in the
distance of 10 to 15 cm from the head and move it evenly. In drying with hot air flow, take
out excessive humidity from hair using a brush or fingers. If you have long hair, bend your
head so that the hair falls down freely from the scalp and face. After you have finished
drying, cool down the dryer by turning the A2 switch to the cool air position and then turn
the A1 switch to the 0 position.
Hair styling
Using diffuser B2 you will add volume to your hair and you will create natural waves. Turn
the A1 switch to the position of the medium temperature and the medium air flow intensity.
Wind on an air strand using the diffuser and let the air flow on it for 2 to 5 seconds (the
time depends on the structure and condition of your hair).
IV. MAINTeNANCe
Turn off the appliance before each maintenance, unplug the power cord from the
power supply and let it cool down! Remove possible impurities from the grid (e.g. using
a brush). Cleaning dust and impurities settled inside the hair dryer can be made by their
vacuuming or blowing out. Wipe the dryer surface with a wet soft cloth. Do not use rough
and aggressive detergents! Maintenance only includes mechanical cleaning.
17
GB
/ 30