ETA Charlotte - Manual (Page 17)

GB
17 / 30
– WARNING: There is a risk of injury in case of incorrect use (not in accordance with the
manual) of the appliance.
– All text in other languages and pictures shown on the packaging, or the product itself, are
translated and explained at the end of this language mutation.
– The producer does not guarantee any loss caused by improper handling of the appliance and
its accessories (e.g. electrical accident, fire, burn, hair damage) and its guarantee for the
appliance does not apply in the case of non–compliance with the safety instructions above.
II. Features of the device (pic. 1)
A – propulsion unit
A1 – temperature and air flow intensity switch
position 0 – off
position 1 – medium temperature and air flow intensity (480 W)
position 2 – medium temperature and air flow intensity (1000 W)
A2 – CARe button – decreases the flowing air temperature
A3 – attachment arrest button A5 – loop for hanging
A4 – turning joint of the power supply A6– supply cord
B – attachments
B1 – hair-drying attachment
B2 – round brush with slide-in spikes 30 mm
(sliding in and out of spikes is controlled with the attachment slider)
B3 – big round brush 50 mm
B4 – undulatory attachment 19 mm
B5 – round brush 33 mm
B6 – round brush with mixed spikes 21 mm
C – Travel case
III. INSTRUCTIONS FOR USE
Remove all packaging material and remove the brush with attachments. Slide on the desired
attachment
B on the propulsion unit A with a slight push and turn it clockwise till you hear
a click (Fig. 2). The correct position for sliding on the attachment is designated by the
protrusions. Plug the fork of the power supply
A6 into the el. socket. Switch the switch A1
either to position 1 or position 2. Turn the appliance off by switching the switch A1 to position
0. Remove the attachment from the propulsion unit by pressing the A3 arrest button and
turning the attachment counterclockwise and pulling off. Pay special attention when changing
attachments (they may be hot).
Use (not for B1) – for slightly wet hair, never wet hair. Moisten dry hair slightly. Before using
the hair brush, comb the hair so that it is not dishevelled. For more permanent effect you can
use styling mousse. When styling hair, never wind very thick hair locks on the brush. Let hot
air take effect on the hair till the hair is warm when touched. Then unwind the curls. Let the
hairstyle cool down before any possible combing.
Creating curls (attachment B4)
Fix the hair lock to the tube with the moving clip, move to the ends of hair and then wind the
lock in a desired direction with 2 – 3 turns.