ETA Žehlička na vlasy 4336 - Manual (Page 14)

II. DESCRIPTION OF THE APPLIANCE
A – hair straightener
A1 – I/O button A5 – Iron´s end
A2 – temperature regulator A6 – turning joint of power cord
A3 – control light A7 – power cord
A4 – heating plates A8 – slider control of jaw lock
B – case
III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the hair straightener. Put the hair
straightener on suitable even surface (see par. I. SAFETYWARNING). Plug power cord
connector A7 to an electric socket. Set regulator A2 to the required temperature (120,
150, 190, 210 or 230 °C) according to the type of hair. Switch on the hair straightener by
pressing A1 button to I position. Control light A3 will turn red, which signals heating of the
plates. As soon as the set temperature is set, control light A3 will turn green. Then the
temperature will be kept automatically. Switch off the appliance after use by pushing A1
button to 0 position (control light A3 will go out) and let it cool down before putting.
Note
– You can change temperature by regulator A2 during hair styling. If you set higher
temperature, wait till the control light turns green. If you set lower temperature, wait for
a couple of minutes before the temperature drops. Then you can continue hair styling.
– While heating the thermostat may cycle (the indicator light turns on and off). This is not
considered to be a defect.
– Turn the regulator only in the range of level 120 to 230 o C. If you turn the button too
much using force, you can damage the regulation system.
i
A2 A1
A4
A5
A6
A7
A8
A3
A
B
14
GB
/ 26