ETA Carolin - Manual (Page 15)

15
GB
A2 – CARE button – decreases the flowing air temperature
A3 – ionization indicator light A6 – turning joint of the power supply
A4 – attachment arrest button A7 – loop for hanging
A5 – support for easy put-away A8– supply cord
B – attachments
B1 – hair-drying attachment
B2 – round brush 32 mm
B3 – round brush with slide-in spikes 32 mm
(sliding in and out of spikes is controlled with the attachment lever)
B4 – round brush with mixed spikes 22 mm
B5 – undulatory attachment 19 mm
B6 – flat shaping and aerating brush
III. INSTRUCTIONS FOR USE
Remove all packaging material and remove the brush with attachments. Press the arrest
button A4, slide on the desired attachment B on the propulsion unit A with a slight push
and turn it till you hear a click. The correct position for sliding on the attachment is
designated by the protrusions. Plug the fork of the power supply A8 into the el. socket.
Switch the switch A1 either to position I (hot air) or position 2 (hot air). Turn the appliance
off by switching the switch A1 to position 0. Remove the attachment from the propulsion
unit by pressing the arrest button A4 and turning the attachment to position and pulling
off. Pay special attention when changing attachments (they may be hot).
Use (not for B1) – for slightly wet hair, never wet hair. Moisten dry hair slightly. Before
using the hair brush, comb the hair so that it is not dishevelled. For more permanent effect
you can use styling mousse. When styling hair, never wind very thick hair locks on the
brush. Let hot air take effect on the hair till the hair is warm when touched. Then unwind
the curls. Let the hairstyle cool down before any possible combing.
Hairstyle shaping and volume (attachment B2, B3, B4)
Place a lock of hair on the round brush and lift the hair at their roots or move the brush
over the hair to their ends and wind the hair in a desired direction, at most with 1,5 turns.
Brush B3 enables you to remove it from hair once the hair has dried. Slide the spikes in by
pressing the lever and then remove the brush from the hair.
Creating curls (attachment B5)
Fix the hair lock to the tube with the moving clip, move to the ends of hair and then wind
the lock in a desired direction with 2 – 3 turns.
Curling and straightening hair (attachment B6)
Brush the hair against their growth direction so that the spikes of the brush touch the skin
of the head. Turn the brush away from the head so that the hair lifts. Straightening hair:
Move the brush slowly on the hair locks, comb them and smarm till dry.
CARE function
Press the A2 button and arrest it by pushing it in the direction of the arrow. The air flow
temperature will decrease which will allow quick cooling and fixation of the hair when
finishing styling. The function is be turned off simply by pushing the button in the opposite
direction.