Iv. instructions for use – ETA Kávovar Inesto User Manual

Page 22

/ 40

Turning on the coffee maker

Press the ON/OFF button and the device starts operating (the ON indicator is on).

Turning off the coffee maker

Press the ON/OFF button twice and the coffee maker will turn off (the

RUN and AUTO

indicator will switch off).

IV. INSTRUCTIONS FOR USE

Remove all packaging material. Remove all adhesive foils, stickers or paper from the

appliance. Place the coffee maker on a flat, stabile, smooth and clean desk at least 85

cm high, out of reach of children and persons mentally incompetent (see par.

I. SAFETY

CAUTION). Allow free space for enough ventilation. Make sure that the supply cord is

not damaged and does not go over any sharp or hot surfaces. The el. outlet must be

easily accessible in order that the coffee maker can be easily disconnected from the el.

outlet in case of danger. Plug the fork of the supply cord

A7 into the outlet. Set the actual

time. Rinse the water system before first use. Fill the tank with water to measure 12, turn

the device on (without the filters and coffee). Pour the water out of the kettle and repeat

approx. twice after the cycle is finished.

Filter

The device is equipped with a permanent filter

B1, in which ground coffee is put.

If you wish to use paper filters, we recommend paper filters s

ize no. 4 or 1x4 which are

commonly available in all domestic appliances shops.

Do not forget to bend the edges of

the paper filter before putting it into holder B to avoid tearing and creasing. Dispose

of the used paper filter with the coffee with other common waste.

Coffee preparation

Tip out the

A1 lid. Fill the A2 tank with fresh cold drinking water in such amount that

corresponds with your consumption. Tip out the holder by pulling it slightly

B. Using the

measure, pour the desired amount of ground coffee into filter

B1 and close the holder with

a snap.

Put the kettle

C on the heating plate A4 and make sure that the container lid is closed.

The coffee maker is set to operation by pressing the

ON/OFF button on the control

panel

A6. The preparation and heating mode is indicated by the indicator light. After the

preparation is finished, the coffee maker switches automatically into the heating mode and

will keep the coffee hot. If you wish to turn the coffee maker off, press the

ON/OFF button

twice and the indicator light will switch off.

Note

The appliance is not active if the indicator lights

AUTO or RUN are not on. Make sure

you do not leave the timer set by accident! The appliance could turn on without water!

Unplug the appliance from the outlet after the making of coffee is finished!

Pausing the coffee preparation

It is possible to take out the glass kettle

C for a while (max. 30 seconds) anytime during

the process of preparation and pour a cup of coffee. The

Drip-Stop valve ensures that

there will be no coffee dripping from the kettle on the heating plate. It is necessary to have

the kettle lid closed for its proper function.