ETA Popi - Manual (Page 18)

Note
If you press the TARE button when the appliance is loaded by the product, the weight
reading will reset on the display. If all products are taken away from the weighing plate,
a negative value will appear on the display.
i
How to weight water
Please press UNIT to change the unit to water (ml). When you put the bowl onto the scale,
its weight will be shown on the display. Please press TARE to clear the weight of the bowl.
The display will show „0“ ml. Then put the water into the bowl, the display will show the
volume of the water.
Auto shut off
Auto shut-off occurs if display shows ‚0‘ or shows the same weight reading for 15 sec.
Manual shut off
To maximize battery life, always touch ON/OFF for 3 seconds to turn off the scale after
using.
Exceeding loading capacity of the scale
Maximum weight for a product weighing is 5 kg. The display will show EEEE Error
message in case the weight of the product on the plate exceeds 5 kg. It means the product
weight exceeds the loading capacity of the scale.
Attention
Remove the excessive weight product from the scales to avoid damage to the
appliance.
!
Error messages shown on the scale display (Fig. 2)
Lo — replace the batteries
EEEE — scale overload, the weight exceeds 5 kg
UNST — unstable indicator - When the scale switched on is it the
unstable state, the LCD will indicate „UNST“. Put the
scale on hard flat surface, leave it recalibrated, it will
work normal
If symptoms such as flashing of the display or erroneous indications
appear, remove the scales away from disturbing sources (e.g.
microwave oven) or turn off the source for the term of weighing.
v. STORAGE
Store the scale after use in horizontal (see I. SAFETY PRECAUTIONS).
2
18
GB
/ 32