ETA Elle - Manual (Page 16)

– If we need lower water temperature than the one that water in the kettle was just
heated to, press the button of the required temperature (the control light of the reached
temperature is on without interruption and the control light of the required temperature
will be flashing). As soon as water in the kettle cools down to this temperature, you will
hear a sound signal = 3 beeps, the control light of the previous temperature goes out
and the control light of the required temperature will be on without interruption. The
same happens even if you enter a requirement for a change from lower to higher water
temperature.
– This appliance is not calibrated for commercial or scientific purposes. Water temperature
can differ by +/- 5 °C in dependence on the selected temperature.
– If smaller amount of water is heated in the kettle than the recommended 0.5 litre, the
difference between the reach and the set temperatures can be even higher.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord
out of the socket! Clean the kettle only when it is cooled down! Do not use rough
and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or other
solvents)! The casing of the electric kettle and the heating bottom is made of top-quality
stainless steel, but in common use, impurities from water get stuck on them (water scale),
particularly above the heating element. It is not rust or another material defect of the
kettle container.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill the kettle to
about one half and mix. After it dissolves, fill the kettle to 3/4 of the maximum amount of
water. Place the electric kettle on the stand and turn it on. Before boiling, turn off the kettle,
let the solution take effect for about 10 minutes and then pour it out. Clean the kettle
thoroughly with clean water. Repeat the whole procedure if the kettle is too soiled. Clean
the electric kettle regularly!
Cleaning the sieve (A6)
Take the sieve from the kettle. Clean it from possible sediments in running water using
a fine brush. Then put the sieve back in the opposite way.
V. ENVIRONMENT
Printed signs of materials used for manufacture, packing, components and accessories,
as well as their recycling, are on all the pieces if their dimensions enable it. The symbols
on the product or in the accompanying documentation mean that the used electric
or electronic products must not be disposed together with municipal wastes. Please,
hand them over to the collection points designed for their correct disposal, where they
will be accepted free of charge. By correct disposal of this product you can help to
preserve valuable natural resources and help to prevent possible negative impacts to the
environment and to human health, which could be the results of incorrect waste disposal.
For further details ask the municipal authorities or the nearest collecting point. Penalties
can be charged for incorrect disposal of such wastes, according to national regulations.
If the appliance is to be put out of operation definitely, we recommend cutting off the feeder
cable, to disable its use.
GB
16 / 43