ETA Vassa - Manual (Page 18)

Food is processed in about 10 seconds to 1 minute. After finishing work, release the
switch, remove the adapter from the container and clean it.
Recommendation
– It is recommended to cut tough ingredients into small pieces. Do not process very hard
materials (e.g. ice cubes, etc.). The knife would be blunt soon.
– Hard ingredients (e.g. legumes, soya beans, etc.) should be soaked in water before
processing.
– The longer you process the food with the mixer, the smoother the result will be.
– In the case of liquids that create foam (e.g. milk), never fill container C up to the „MAX“
gauge mark to prevent overflowing.
– If you are not satisfied with the result, switch off the appliance, mix the ingredients with
spatula, take some part of the ingredients or add a little liquid.
Amount of the food and processing times
Food Max.amount Time
Baby food, soups and sauces 100 – 500 ml 60 sec.
Shakes and mixed drinks 100 – 500 ml 60 sec.
Fruits and vegetables 100 – 200 g 30 sec.
Batters 100 – 500 ml 60 sec.
V. STORING AND CHARGING THE PROPULSION UNIT
1) If the indicator starts flashing at the “MIN” level during operation, turn the appliance off.
2) Remove the blending attachment and place it into the charging attachment. The
blending attachment may be placed in the stand as well but only in a compartment that
is not intedned for charging the appliance. (pic. 3)
3) Plug in the charging connector into the charging socket that is placed in the charging
attachment. Then plug the charging adaptor into an el. outlet. The charging indicator will
flash. The appliance is equipped with 3 LED indicators. If all three are lid (up to the MAX
level), the appliance is charged and ready for use.
4) Charging of the battery takes approx. 2 hours. Battery capacity is about 15 minutes.
5) After the appliance is charged, unplug the charging adaptor from the el. outlet and the
charging attachment. Leave the appliance in the charging attachment that also serves
for storing or take it out of the charging attachment and assemble it and use it as
desired.
VI. MAINTENANCE
Do not use rough and aggressive detergents!
Clean drive unit A with soft and wet cloth with a little detergent. Make sure that water
does not get inside the appliance! Wash the accessories in hot water with detergent
right after use, rinse it in clean water and wipe till dry (you can also wash accessories C
in a dishwasher - but not mixer B). The end piece with the shaft of mixer B must not be
immersed during cleaning.
Be very careful when cleaning mixing adapter B. Make sure that the cutting edges of the
accessories are not in contact with hard objects that make them blunt and thus they reduce
their effectiveness.
18
GB