ETA Lancetta - Manual (Page 16)

– Do not insert to or take out the plug from a socket with wet hands and do not pull
the power cord!
– Do not leave the iron plugged in power supply without supervision!
– after finishing work, always disconnect the appliance from power supply by taking
the connector of the power cord out of the electric socket.
– The product is intended for home use and similar (in shops, offices and similar
workplaces, in hotels, motels and other residential environments, in facilities
providing accommodation with breakfast). It is not intended for commercial use!
– The thermostat can never be used as a switch!
– Never immerse the appliance into water (even its parts)!
– Do not place the iron in such a way that could represent harm (e.g. fire, burn and
scalding).
– Due to production tests, the internal iron container can be misted up. Do not consider it to
be a defect when purchasing the iron.).
– When switching the iron for the first time, set the highest temperature and let the iron in
operation on for at least 10 minutes without water. There can be light fume coming out
of the iron which is caused by burning of the used lubricants and binding agents in the
steam chamber.
– After finishing work, always disconnect the appliance from power supply by taking the
connector of the power cord out of the electric socket.
– When filling in the container with utility water for the first time, we recommend letting out
the steam from the entire container outside the ironed fabric.
– Never pour water to the container that was produced by defrosting of a freezer, water
condensed in a dryer, air-conditioning or dehumidifying units, certain types of mineral
waters, water enriched with alcohol, perfume and preparations for treatment and for
stiffening fabrics (e.g. starch, fabric conditioners) or vinegar, decalcifying agents,
softeners or other chemical substances.
– Whenever you fill the container with water during ironing and empty the container after
ironing, unplug the iron from the electric power.
– When ironing, be very careful, tilting of the iron may result in the hot water pouring out of
the filling hole.
– Make sure that the power cord does not hang over the edge of the working table where
children could reach it.
– Never iron clothes on people.
– Check the condition of the power cord of the appliance regularly.
– Make sure that the power cord is always dry and it is not damaged.
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– If the power cord of the appliance is corrupted, it has to be replaced by the producer, its
service technician or a similarly qualified person so as to prevent dangerous situations.
– Never use the appliance for any other purpose than for that described in these
instructions for use! Iron is not intended for use in places with explosive danger.
– The producer is not responsible for damage caused by improper use of the appliance
(e. g. burning, scalding, fire, clothes damage, scratching and contamination of the
ironing plate) and its guarantee for the appliance does not apply to situations when the
safety warnings above have not been complied with.
16
GB
/ 58