ETA Viento - Manual (Page 23)

Ironing without steaming
Plug the power cord M to electric socket; control is lit. Put the iron to the rest position (Fig.
7). Turn the steaming regulator D to the 0 position, steaming off (fig. 5) or pour out water
from the container I. Set the program on the display using regulation wheel H according to
the selected fabric material (Fig. 2). Reaching the required temperature is shown by turning
the indicator lamp G OFF.
WARNING
– During ironing the thermostat will cycle, which is accompanied by characteristic sound
(clicking). This is normal situation and does not form the reason for warranty claim related
to the appliance.
Recommendation
Control H (Fig. 2) is marked with international symbols that recommend the optimum
ironing temperature and they are the same as marking on some types of laundry
and textiles (Fig. 3). When the temperature is increased from the cold state or if the
temperature is set from higher to lower, we recommend waiting for a while (see the
information on the display and listen for sound signalling) due to stabilization of the ironing
plate temperature.
Steam ironing
Hold the iron in your hand, turn the steaming regulator D to the position 0 (Fig. 5) and slide
the cover C to open the filling container lid. Pour in water to the container I (Fig. 4) with the
enclosed cup O and close the filling hole lid in the opposite direction. Keep the position of
the iron for pouring in water. Put the iron to the rest position (Fig. 7) and set the regulation
wheel H to the marked area for steaming (Fig. 2 - ). Plug the power cord M to a socket.
When the control light G goes off, move the steaming regulator D away from handle. The
more you move the regulator towards MAX, the bigger amount of outgoing steam there will
be (Fig. 5). Place the iron to the rest position, automatic creation of steam will stop (more
steam may be going out for a short time).
Warning
- For all normal ironing the middle adjustment of the steam amount is recommended. Only
on ironing the linen fabric, thick cotton and similar fabrics the adjustment of the steam
amount to maximum value is recommended. Setting to high-pressure steam ironing os
recommended only if the regulation wheel H is set to temperature setting •••.
- Be extra careful to avoid accidental pushing of the SELF cLEAN button.
- When water container I is filled with water over the permitted limit ( MAX. 300 ml), steam
can be created even in the rest position.
- At places with hard water we recommend diluting it with distilled water. You will get
the information about water hardness at the water-management authorities, or at the
local sanitary station. For water hardness > 15 °N we recommend filling the iron in the
following ratio:
Water hardness Ratio of tap water : distilled water
medium 2 : 1
hard 1 : 1
very hard 1 : 2
23
GB
/ 45