Owner’s manual, Installation, Continued – Desa FSVYD18P User Manual

Page 11

104462

OWNER’S MANUAL

INSTALLING GAS LOG
HEATER INTO STOVE

Remove log and gas log heater from
carton.

Note:

Do not pick up gas log

heater by the burner itself. This could
damage heater. Always handle the gas
log heater by the heater base only.

Remove all protective packaging applied
to log and gas log heater for shipment.

Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.

If not already removed, remove back
panel from assembled stove body (see
Figure 5, page 8). Use an adjustable
wrench or a 10 mm socket. Remove six
(6) bolts and washers. Keep bolts and
washers to reattach back panel later.

Set gas log heater inside stove. Make sure
control knob extension passes through
bottom front opening (see Figure 15).

Align outside holes on heater base with
four (4) mounting holes on the stove
bottom (see Figure 15).

INSTALLATION

Continued

Fasten heater base to stove bottom with
#10-24 x .50 bolts and hex nuts pro-
vided with gas log heater (see Figure
16). Attachment hardware is factory
packed inside plastic bag with installa-
tion manual and owner’s registration
card. Push bolt through heater base
mounting hole and through stove bot-
tom. Connect hex nut to bolt on under-
side of stove bottom. The bolt hex head
is for a 5/16" socket and the hex nuts
are for a 3/8" socket. If sockets are not
available, use adjustable wrenches.

Set one-piece log on heater base as
shown in Figure 17. Make sure middle
section at bottom of log is seated into
"U" shaped cutout in center of heater
base. Log will fit securely on base.

IMPORTANT:

Make sure log does not

cover any burner ports and does not
touch the stove cavity (see Figure 18).

Fasten back panel to stove with six (6)
M6 x 1.20mm bolts and washers. Make
sure product identification label is located
on the outside lower left-hand corner.

10. Place freestanding stove in desired po-

sition in room. Be sure to maintain
clearances to combustibles as outlined
on page 7.

Continued

CAUTION: Do not remove the

data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.

WARNING: Failure to position

the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.

CAUTION: After installation

and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.

O
F

Figure 15 - Placing Heater Base In Stove
Cavity (Appearance May Vary Depending
on Model)

Figure 16 - Fastening Heater Base to
Stove Drop Bottom

Stove
Bottom

Heater
Base

Bolt

Hex Nut

Burner Porting Areas
(double slotted
rectangular openings

Figure 18 - Top View of One-Piece Log
Set on Gas Log Heater

Safety Pilot Location

One-Piece
Log Set

"U" Shaped
Cutout in
Chassis

Burner

Middle
Section at
Bottom of
Log Set

Bottom
Front
Opening

Stove Bottom

Burner

Bolt

Heater
Base

Figure 17 - Installing One-Piece Stove
Log Set (Remote-Ready Log Heater
Shown)

Heater Base