ETA Dualic II - Manual (Page 29)

29
GB
/ 48
Storing the accessory
One of the attachments (e.g. cushion, slit nozzle and brush) may be slid onto the holder
that is fixed to the telescopic tube. The remaining accessory, floor nozzle, suction tubes
and hose may be disassembled or left assembled and hung into the parking openings A14
on the back panel or bottom of the vacuum cleaner. Always store the floor nozzle in the
carpet setting (with the brush inside) to avoid bending of the bristle.
V. MAINTENANCE
Store the vacuum cleaner at a dry place, far enough from heat sources (e.g. fireplace,
stove, heating element) and protect it against weather conditions (e.g. rain, sunshine).
Treat the appliance surface with a soft damp cloth, do not use coarse and aggressive
detergents! Store the appliance properly cleaned at a dry, dust free place out of reach
of children and incapacitated people.
Floor nozzle
It is recommended to check the brushes or collectors for possible impurities. If there are
some impurities, remove them.
VI. TROUBLESHOOTING
Problem Cause Solution
Motor won‘t start Power supply not connected
The button is not switched
on
Check the cord, plug and the socket
Press the switch button
The lid cannot be
closed - safety
lock activated
Wrongly inserted dust
container
Dust filter not inserted
properly
Check/repair fixture of the dust
container
Check/repair fastening of the carton
front
The dust
container or
filter can not be
removed
The hose is not disconnected
Holder inserted incorrectly
in the suction space of the
vacuum cleaner
Disconnect the suction hose of the
vacuum cleaner
Check/repair insertion of the holder
in the suction space of the
vacuum cleaner
Suction power is
insufficient
Regulation is at MIN
Open sucking
Full dust container
Dust bag is full
Clogged micro filters
Nozzle, sucking hose or Hose
is clogged.
Set the regulator to MAX
Close the opening on the hose
holder
Empty the container
Replace the dust bag
Replace or clean the micro filters
Remove the blocking objects
The cable cannot
be wound in the
entire length
Twisted cable Straighten the cable Take out about
50 cm of the cable and push again
the button