ETA Silentino - Manual (Page 28)

The front cover of the brush cylinder (depending on model) can be removed for easier and
more comfortable maintenance by releasing the arrest latches on its sides and sliding it out.
At the same time, make sure no dirt is stuck on the inner side of the nozzle (i.e. turbine).
Release the two arrest latches on the bottom side of the nozzle in the direction of the arrow
and remove the cover. Clean the space with a suitable tool (e.g. tweezers). Insert the covers
back into the nozzle reversely and close it with by folding it up (you hear an audible click).
VI. TROUBLESHOOTING
Problem Cause Solution
Motor won‘t start Power supply not connected Check the cord, plug and the socket
button is not switched on Push button
Lid cannot be
closed - safety lock
activated
Dust filter inserted incorrectly in the
holder / adapter
Check / repair fastening of the front in
the holder / adapter
Suction output is
not sufficient
Regulation in MIN position Set regulation to MAX.
Dust filter full Replace the filter
Clogged micro-filters Clean or replace the micro-filters
Nozzle, suction hose or tube is clogged Remove blocking objects
The cable cannot
be wound in the
entire length
Twisted cable Straighten the cable
Take out about 50 cm of the cable and
push again button
VII. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electrical or
electronic products must not be disposed of together with municipal waste. For proper
disposal of the product, hand it over at special collection places where it will be taken
over free of charge. Suitable disposal of the product can help to maintain valuable natural
resources and to prevent possible negative impacts on the environment and human health,
which could be the possible consequences of improper waste disposal. Ask for more
details at the local authority or at the local waste collection site. Fines can be imposed for
improper disposal of this type of waste in agreement with the national regulations. If the
appliance is to be put out of operation, we recommend its cutoff after disconnecting it from
power supply and in this way it will not be possible to use the appliance again.
Replacement of parts that require intervention in the electric part of the appliance
must be carried out by a specialized service! Failure to comply with the instructions
of the manufacturer will lead to expiration of the right to guarantee repair!
GB
28 / 45