ETA Canto - Manual (Page 22)

IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A10 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories C1, C2, C3 (Fig. 2, 3, 4). If the cleaner is fitted with telescopic
tube C3, adjust its length to fit your figure (Fig. 5). Floor nozzle C1 is designed to be
used to clean carpets or smooth flooring (Fig. 6). If the floor nozzle is fitted with a brush,
pull it out by switching over a flap when vacuuming hard floorings. You can use crevice
nozzle C6, C7 for vacuuming places that are hard to access (Fig. 7). TURBO nozzle C9
or upholstery nozzle C4 or brush C5 can be used to clean various types of furniture (Fig.
8, 9). The vacuum cleaner can be switched on or off by pushing button A4 marked with
the symbol (Fig. 10). The suction power can be adjusted with the control on hose
handle C2 (Fig. 11) or by setting regulation A6 (Fig. 10). The minimum suction power
is recommended for fine fabrics (e.g. curtains, drapes). The maximum suction power is
recommended for floor coverings (e.g. heavy-duty carpets). After finishing work, switch
off the vacuum cleaner and unplug it from the power supply. By switching button A5 with
symbol (Fig. 10) the power cord will be wound automatically. The vacuum cleaner can
be held and carried by handle A9.
Full dust filter signaling
If the coloured field is displayed permanently on the indicator A7 (Fig. 12) while the floor
nozzle is lifted above the cleaned surface at the maximum suction power, the dust filter
must be replaced.
Disregard changes on the indicator during vacuuming.
Dust filter replacement
lift off vacuum cleaner lid A3 by pushing lock A2 to the locked position (Fig. 13). Then
follow the instructions for the respective type of a dust filter:
Paper / synthetic filter: pull out the dust filter lock A16 from the guide ribs of the holder
A15 (Fig. 14) and dispose it with common municipal waste. Slide
the front part of the dust filter (in the direction of the arrow) to
holder A15 in the suction space of the vacuum cleaner and push
it to the maximum position.
UniBag: hold adapter B and remove it from the guide ribs of holder A15 by pulling it
(Fig. 14). By lifting off lock stop B1, dust filter A16 will be released from the
holder/adapter (Fig. 15). Dispose of the dust filter with common municipal waste.
Slide the projections on the front of a new dust filter into the holes in adapter
B and secure the front by slight pushing. You will hear a clicking sound. Check
proper fastening of the front by slight pulling of the dust filter. Slide the adapter
with a filter to the holder in the suction space and push it to the maximum
position.
Close the vacuum cleaner lid by snapping it shut. You will hear a clicking sound.
Replacing micro-filters
After replacing about 5 dust filters, micro-filters must be cleaned or replaced with new
ones. Dispose of the used dust filter and the micro-filters with common municipal waste.
You can buy replacement filters and micro-filters in electro store chain.
22
GB
/ 62