beautypg.com

ETA Manoa Animal User Manual

Page 28

background image

Paper / synthetic filter: pull out the dust filter lock A16 from the guide ribs of the holder A15

(Fig. 14) and dispose it with common municipal waste. Slide the

front part of the dust filter (in the direction of the arrow) to holder

A15 in the suction space of the vacuum cleaner and push it to the

maximum position.

UniBag: hold adapter B and remove it from the guide ribs of holder A15 by pulling it

(Fig. 14). By lifting off lock stop

B1, dust filter A16 will be released from the holder/

adapter (Fig. 15). Dispose of the dust filter with common municipal waste. Slide the

projections on the front of a new dust filter into the holes in adapter

B and secure

the front by slight pushing. You will hear a clicking sound.

Check proper fastening of the front by slight pulling of the dust filter. Slide the adapter with

a filter to the holder in the suction space and push it to the maximum position. Close the

vacuum cleaner lid by snapping it shut. You will hear a clicking sound.

Note

– Proper fixing of the cardboard front of a dust filter to the holder / adapter and proper

sliding of the holder with the filter to suction space of the vacuum cleaner will result in

releasing mechanical safety lock that will make it possible to close vacuum cleaner lid

A2.

– Safety lock does not enable closing the vacuum cleaner lid if you forget to insert a dust

filter (paper, synthetic or textile).

i

Replacing micro-filters

After replacing about 5 dust filters, micro-filters must be cleaned or replaced with new ones.

Dispose of the used dust filter and the micro-filters with common municipal waste. You can

buy replacement filters and micro-filters in electro store chain.

Suction micro-filter

Take out grid

A8 with filter A17 by pulling it upwards (Fig. 16). Remove the filter from the grid

(Fig. 17) and clean it in running lukewarm water, e.g. using a cloth or a soft brush and let it dry

completely (Fig. 19). After drying, put the grid with a new micro-filter in the opposite direction

behind the guide ribs and slide it to the suction area of the vacuum cleaner to the maximum

position.

ATTeNTION

– The „UniBag” dust filter is not intended for repeated use.

– DO NOT THROW THE ADAPTER AWAY!

– Do not use any aggressive washing or cleaning agents or hot water to clean the HEPA filter

and the micro-filter.

– Cleaning the filter will not restore its original colour, but it will restore its filtration properties.

– The HEPA filter and the micro-filters are not intended for cleaning in a dishwasher.

– Neglecting regular replacement of micro-filters can result in the vacuum cleaner failure!

– Make sure that the contact surfaces and sealing elements are functional.

– We recommend replacing the HEPA filter twice a year. Replace the other micro-filters if they

cannot be cleaned properly or if they are damaged. You can buy a replacement dust filter,

a HEPA filter and a micro-filter in the elektro shop chain.

!

exhaust micro-filter

Take out exhaust grid

A12 from the vacuum cleaner by pulling it upwards (Fig. 18). Take out

foam filters

A13 from the grid and remove Tap the dust out of the filter over a dustbin or to clean

the filter through a blowing (we recommend the filter cleaning outside of living area for hygiene

reasons).

28

GB

/ 48

This manual is related to the following products: