beautypg.com

Technical specifications, Rta1046vw), All-in-one integrated access device – Dynalink ADSL2+ Wireless VoIP Router RTA1046VW User Manual

Page 2

background image

All-in-one Integrated Access Device

Technical Specifications

(RTA1046VW)

• Voice Transport: compliance to RTP (RFC1889)

• Voice Codec: G.711 (a-law and u-law),

G.726 and G.729

• Tone/Ring Signal: compliance to Australia & New

Zealand standards.

• Tone Detection: support DTMF

• Echo Cancellation: G.168 compliance

• Support FAX/Analog Modem function via

PSTN port

• Support RFC2833 RTP Payload for DTMF Digits,

Telephony Tones and Telephony Signals

• Two VoIP (FXS) ports for VoIP phone calls

supporting intelligent lifeline backup when there
is no Internet service.

• Manual selection of PSTN mode or VoIP mode for

making phone calls

• Automatic selection of PSTN when an emergency

number is dialled.

Routing

• NAT / PAT allows multiple users to share

Internet access

• UPnP IGD with NAT traversal capability

• Port Forwarding: users can setup multiple virtual

servers (e.g., Web, FTP, Mail servers) on the
local network.

• Static routing & dynamic routing RIPv1/v2

• DNS Relay, Dynamic DNS

• DHCP Client/Relay/Server

• IGMP Proxy

• Support IP/Bridge QoS for different traffic classes

• Support 802.1Q VLAN Tagging

Configuration and Management

• Embedded web configuration interface with

password protection

• Remote management control

• Telnet session for local or remote management

• System events logging

• DSL connection diagnostics

• Firmware upgrade via web browser

• User setting backup & restore

• SNMPv1/v2 agent with MIB-II, ADSL Line MIB

ADSL Compliance

ADSL

• ANSI T1.413 Issue 2

• ITU G.992.1 Annex A (G.dmt)

• ITU G.992.2 Annex A (G.lite)

• ITU G.994.1 (G.hs)

• Support dying gasp

• Maximum Rate: 8 Mbps downstream and

1 Mbps upstream

ADSL2

• ITU G.992.3 Annex A (G.dmt)

• ITU G.992.4 Annex A (G.lite)

• Maximum Rate: 12 Mbps downstream and

1 Mbps upstream

ADSL2+

• ITU G.992.5 Annex A (G.dmt)

• Maximum Rate: 24 Mbps downstream and

1.2 Mbps upstream

ATM

• PPPoA (RFC 2364) and PPPoA Bridged mode

• PPPoE (RFC 2516) and PPPoE Bridged mode

• IPoA (RFC 2225)

• Bridged mode over AAL5 (RFC2684/1483)

• ATM Forum UNI 3.1 / 4.0 compliant PVCs

• UBR and CBR with traffic shaping

• OAM F4/F5 loopback cells

Bridging

• IEEE 802.1d self-learning bridge

• Learning up to 4096 MAC addresses

• Transparent Bridging between 10/100 Mb

Ethernet and USB

• Supports IGMP Snooping

• Supports 802.1Q VLAN packet pass-through

Voice over IP Features

• Call Feature: basic outgoing and incoming

call, Call Waiting, Three Party Conference, Call
Transfer, Caller ID (only when supported by
service provider).

• Call Control: SIP (RFC3261)

www.dynalink.co.nz

www.dynalink.com.au