EM Acoustics M-10 compact passive stage monitor User Manual
Page 6
6
M-10 User Manual
www.emacoustics.co.uk
M-10 MONITORS IN USE
The M-10 monitors were designed to deliver unprecedented performance without the expensive requirement of
active controllers and dual amplifier channels. They are intended for lower-SPL applications – small theatre,
houses of worship and conference centres for example – where a general mix over a wide area is desired rather
than intense “hotspots”. Despite the small enclosure size and footprint, the M-10 still produces a very useable
amount of low frequency information.
STAGE ORIENTATION
The HF unit in an M-10 is on the left-hand side as you look at the monitor. This is easily denoted as the badge in
the grille sits over the 10” drive unit on the right. When arranging on stage, the position of an M-10 relative to
other monitors on stage will affect the sound. We recommend experimenting to get the performance that suits
you best, however having the monitors 50cm apart is a good place to start.
For drum fill applications, the M-10 can be stood on-end if required (badge at the bottom) and this will produce a
coverage pattern of 60°H x 80°V.