Directed Electronics 650 - Manual (Page 15)

QUICK REFERENCE OPERATING CARD
To arm using your remote
▼ Press button I for less than a second. When armed the siren chirps
once and the parking lights flash once.
Arming
▼ Press Button I of your transmitter for one second. When the system
arms, you will hear a short chirp, and see the parking lights flash
once. If the vehicle’s power door locks are controlled by the system,
the doors will lock.
Arming While Driving
▼ Press Button I on your transmitter while the vehicle is running. The
system will chirp once and then once more to indicate that the igni-
tion is on.
Disarming
▼ Press Button I. You will hear two chirps, and the parking lights will
flash twice. If power locks are controlled by the system, the doors will
unlock.
Disarming Without a Transmitter
▼ Turn on the ignition. Push the Valet switch within 15 seconds. The sys-
tem should now disarm. If it does not, you may have waited too long,
so turn the ignition off and on and try again.
Silent Mode TM
▼ Press Button II briefly before arming or disarming, and the confirmation
chirp(s) will be eliminated for that one operation only.
Panic Mode
▼ Press Button I for 1.5 seconds, and you will enter Panic Mode. The
siren will sound and the parking lights will flash for 30 seconds.
To enter or exit Valet Mode with the Valet switch
▼ Turn ignition to "run" position, then turn to "off" position. Press and
release the Valet switch within 10 seconds. The Status LED will light
steady if you have entered Valet Mode, and it will go out if you exited
Valet Mode.
Using Remote Valet as you enter or exit the vehicle:
▼ Open any door. Press Button I, Press Button II, Press Button I again.
The Status LED will light steady if you have entered Valet Mode, and
it will go out if you exited Valet Mode.
Cut along dotted line and f
old where indicated f
or a quic
k and easy ref
erence to keep in y
our pur
se or wallet.
✂